1066 dbx
G2B 식별번호 : 23140570

Compressor / Limiter / Gate

1066은 장비를 손상시킬 수 있는 피크 및 과전류를 방지하여 주는 프로세서로서, 압축, 리미터 기능을 통해 고르지 않은 레벨을 부드럽게 처리하고 고가의 앰프와 스피커를 보호합니다. 또한 선택 가능한 입력 및 출력 미터링을 통해 레벨별로 일치하는지 확인 할수 있고 VCA는 매우 낮은 왜곡과 잡음 특성을 유지 합니다.

선택 가능한 자동 또는 수동 압축
원하지 않는 저주파 제거
최소한의 왜곡으로 최대 허용 레벨 설정
외부 장치 설정 및 모니터링 가능
금도금 XLR 1/4 "입력 및 출력
True RMS 레벨 감지
입력 레벨, 출력 레벨 및 게인 감소의 정밀 계량
트루 스테레오 또는 듀얼모노작동
채널당 + 4dBu 또는 -10dBV 전환 가능

Input ConnectorsXLR and 1/4" TRS (Pin 2 and tip hot)
Input TypeElectronically balanced/unbalanced, RF filtered
Input ImpedanceBalanced > 50 kOhm, unbalanced >25 kOhm
Max Input> +24 dBu balanced or unbalanced
CMRRTypically >50 dB at 1 kHz
Output ConnectorsXLR and 1/4" TRS (Pin 2 and tip hot)
Output TypeServo-balanced/unbalanced, RF filtered
Output ImpedanceBalanced 120 Ohm, unbalanced 60 Ohm
Max Output> +21 dBm balanced, > +20 dBm unbalanced
Sidechain Input Connector1/4" Unbalanced (Tip-Sleeve)
Sidechain Input TypeUnbalanced, RF filtered
Sidechain Impedance>10 kOhm
Sidechain Max Input Level>+24 dBu
Sidechain Output Connector1/4" Balanced TRS (tip hot)
Sidechain Output TypeImpedance balanced, RF filtered
Sidechain Output ImpedanceBalanced 2 kOhm, unbalanced 1 kOhm
Sidechain Max Output Level>+21 dBu balanced or unbalanced
Bandwidth20 Hz to 20 kHz, +0/0.5 dB
Frequency Response0.35 Hz to 90 kHz, +0/-3 dB
Noise< -95 dBu, unweighted, 22 kHz measurement bandwidth
Dynamic Range> 118dB, unweighted
THD+Noise0.008% typical at +4 dBu (1 kHz unity gain), 0.08% typical at +20 dBu (1 kHz unity gain), < 0.1% any amount of compression up to 40 dB, 1 kHz
IMD< 0.1% SMPTE
Interchannel Crosstalk< -80 dB 20Hz to 20 kHz
Stereo CouplingTrue RMS Power Summing
Compressor Threshold Range-40 dBu to +20 dBu
Compressor Ratio1:1 to infinity:1
Compressor Threshold CharacteristicSelectable OverEasy® or hard knee
Compressor Attack/Release CharacteristicAutoDynamic™
Compressor Attack/Release ModesSelectable Manual or Auto
Compressor Manual Attack TimeScalable program-dependent
Compressor Manual Release TimeScalable program-dependent
Compressor Auto Attack TimeProgram-dependent
Compressor Auto Release TimeProgram-dependent
Compressor Output Gain-20 to +20 dB
Limiter Threshold Range+4 dBu to +24 dBu (off)
Limiter Ratioinfinity:1
Limiter TypePeakStopPlus® two-stage limiter
Limiter Stage 1PeakStop® brickwall limiter
Limiter Stage 1 Attack TimeZero
Limiter Stage 1 Release TimeZero
Limiter Stage 2Predictive intelligent program limiter
Limiter Stage 2 Attack TimeProgram-dependent
Limiter Stage 2 Release TimeProgram-dependent
Expander/Gate Threshold RangeOff to +15dBu
Expander/Gate Ratio1:1 to 30:1
Expander/Gate Attack Time< 100 µsec
Expander/Gate Release TimeProgram-dependent
SC Ext. SwitchRoutes the external sidechain input signal to the detector
SC Mon. SwitchRoutes the sidechain signal to the output, interrupting the normal audio
OverEasy® SwitchActivates the OverEasy compression function
Countour SwitchActivates the frequency-dependent detector function
Auto SwitchActivates automatic program-dependent attack and release times, disabling the manual Attack and Release controls
I/O Meter SwitchSwitches between monitoring input and output levels on the Input/Output Level meter
Bypass SwitchActivates the direct input-to-output hard-wire relay bypass. Relay automatically hard-wire bypasses unit at power-down and provides a power-on delay of 1.5 sec.
Operating Level Switch(rear panel) Switches the nominal operating level between -10 dBV and +4 dBu simultaneoulsy for both input and output levels
ST Link SwitchLink both channels for stereo operation. Channel One becomes the master
Gain Reduction Meter12-segment LED bar graph at 1, 2, 4, 6, 9, 12, 15, 18, 21, 24, 27 and 30 dB
I/O Meter8-segment LED bar graph at -24, -18, -12, -6, 0, +6, +12, and +18 dBu
Compressor Threshold Meter3-segment LED bar graph at Below (-), OverEasy and Above (+)
Expander/Gate Threshold Meter2-segment LED bar graph at Below (-) and Above (+)
Limiter Threshold Meter1 LED to indicate PeakStopPlus™ limiting
Function SwitchesLED indicator for each front-panel switch
Output Transformer OptionsJensen® JT-123-dbx or JT-11-dbx, BCI RE-123-dbx or RE-11-dbx
Operating Voltage100-120 VAC 50/60 Hz 200-240 VAC 50/60 Hz
Power Consumption20 Watts
Fuse100-120 VAC:250 mA Slow Blow, 200-240 VAC:125 mA Type T
Power ConnectorIEC receptacle
Dimensions1.75"Hx19"Wx9"D (4.4cmx48.3cmx20.1cm)
Unit Weight5.1 lbs. (2.3 kg)
Shipping Weight7.5 lbs. (3.4 kg)


<개인정보처리방침>